The series of Belt Shot Blast Machine by high-speed projectile impact on the surface of the workpiece to wear a strong wear equipment, high-speed projectile once flying out may be damaged or damaged near the architectural glass. Therefore, to ensure safe production, the establishment of regular inspection and maintenance system is very important.
1, after each class should be crawler Belt Shot Blast Machine sweep again.
2, should always check the cleaning room in the guard and Belt Shot Blast Machine directional sets, sub-balls and other wear and tear, if serious wear and tear, should be replaced immediately.
3, Belt Shot Blast Machine before the operation, where there are sports parts are required to lubricate the shot on the spindle bearings, 2 # calcium-based grease once a week. Screw conveyor, the elevator on the bearing, plus 2 # calcium-based grease once a month. The remaining bearings every 3 to 6 months plus 2 # calcium-based grease once. Chain and other parts of the activities once a week, once the mechanical oil, the motor lubrication on demand lubrication.
4, regularly check each transmission parts, cleaning parts, replace the wear parts.
5, crawler Belt Shot Blast Machine in the inspection and maintenance, you must cut off the power to avoid accidents.
6, the machine work 48 hours to check the fan, and remove the dust attached to the wheel, to ensure smooth operation of the fan and service life.
7, cleaning room of the guard plate can be replaced regularly according to the situation, the replacement, the protection of the plate should be installed in the control of the gap within 1.5 mm.
8, the track replacement, the front door to open, remove all the interference pieces, with 10 # steel bars to do four hooks from the upper part of the body of the hole to the drive shaft and track suspension, the crawler from the door into the pressure.
We're Here to Help